Xfer Records Shrub: a free, stripped-down Serum for the M-VAVE FM-1
Xfer Records releases Shrub, a free, stripped-down Serum for the M-VAVE FM-1: firmware, web editor and VST3. What it keeps, its limits and what it competes with.

Xfer Records, the company behind Serum, has released Shrub, a stripped-down version of its wavetable synth built to run on the M-VAVE FM-1, the small battery-powered FM synth. Shrub is free and in beta. It comes as firmware for the FM-1 (version V1.00), an editor that runs in the browser, and a VST3 plugin for macOS, Windows and Linux. This article is based on the official Shrub website and its operation guide, written by Steve Duda.
Three ways to play Shrub
- Firmware for the FM-1: installed from a web page over USB in about two minutes. It needs Chrome or Edge, the only browsers with the Web MIDI support the installer uses.
- The web editor: it plays Shrub right in the browser with no FM-1 attached, and edits the hardware live when it is connected. It imports Serum 1 presets (
.fxpfiles), exports to Serum 2, loads your own wavetables and builds banks. - The VST3: the same editor and engine inside your DAW, with the same sound as the firmware. At the time of writing, the official page lists the plugin downloads as “coming soon”.
The VST3 format is covered in our guide to VST3, AU, AAX and CLAP plugin formats.
Xfer warns that the VST3 is not built primarily for desktop use: it runs the FM-1’s own code, so it uses more CPU than its light interface suggests. Its main job is to act as an editor and librarian.
What Shrub keeps from Serum
Serum is a wavetable synth: each oscillator reads a stack of waveforms and sweeps through them, so the timbre changes over time. The principle is explained in our article on wavetable synthesis.
Oscillators
Two wavetable oscillators, with 64 built-in tables (Serum 2’s, a selection from Serum 1 and a few calculated ones), user tables and an additive mode that builds a table harmonic by harmonic. The warp modes are Serum’s own. Each oscillator offers unison from 1 to 8 voices: several slightly detuned copies of the same note that thicken the sound. A sub oscillator (six shapes) and a noise generator (five colours) complete the set.
Filter
Shrub carries 76 of Serum’s filter types, including Serum 2’s ladders and French LP. But there is a single filter for every note: a paraphonic, shared filter, where Serum gives each voice its own. A single note sounds just like Serum; on a chord, every note goes through the same cutoff and the same filter envelope. The difference between polyphony and paraphony is covered in polyphonic, paraphonic and monophonic synths.
Modulation, effects and performance
- Three envelopes with Serum’s curves: ENV 1 sets each note’s volume, ENV 2 and ENV 3 are shared by all notes. Each stage is explained in our guide to the ADSR envelope.
- Four LFOs (low-frequency oscillators that move a setting in a loop) and two chaos sources, routed through a 16-slot modulation matrix.
- Serum 1’s effects rack: distortion, chorus, delay, compressor (with OTT mode), reverb, EQ and filter.
- An arpeggiator, an eight-lane motion sequencer and 51 scales.
- 128 preset slots, 100 of them filled with factory presets in seven categories.
Limits worth knowing
| Item | What the official guide says |
|---|---|
| Polyphony | 4 notes at once, up to 8 unison voices per oscillator, from a pool of 16 voices |
| Filter | One filter shared by all notes (paraphonic) |
| FM-1 keyboard | 27 keys, fixed velocity of 100 |
| Installation | Chrome or Edge on a computer, USB cable |
| Status | Beta, not made or supported by M-VAVE, install at your own risk |
| Going back | Always possible to M-VAVE’s firmware: the FM-1’s boot code is never touched |
Who it is for
- FM-1 owners who want a second personality for the box: a subtractive wavetable synth instead of an FM synth.
- Serum users looking for a pocket instrument that can load their Serum 1 presets.
- Less suited to players who mostly want rich chords: four notes and one shared filter make it a bass, lead and sequence synth first.
What it costs
Shrub is free: firmware, web editor and VST3. M-VAVE does not state a recommended retail price for the FM-1 on its official pages: price not disclosed.
What it competes with
- M-VAVE FM1 Open: the official alternative firmware for the FM-1, also free, which turns it into a small eight-track station with six engines (FM, acid bass, drums, sampler and more). We covered it in M-VAVE FM1 Open V13. More complete as a groovebox; Shrub goes deeper on a single engine, Serum’s.
- Korg NTS-1 digital kit mkII: another small programmable synth, open to third-party oscillators and effects through the logue SDK, but sold as a kit and without Serum’s wavetable engine.
- On a computer alone, Vital, a wavetable synth whose basic version is free, is better suited to the desktop, since Shrub is not optimised for it.
More free software covered by the site is in the free and open-source section.


