Memorymoog Plus: Eric Frampton’s +EF firmware rebuilds MIDI and the arpeggiator
+EF, a from-scratch firmware for the Memorymoog Plus, promises MIDI note-ons up to 2.5 times faster, SysEx and MIDI clock sync. On sale December 1.

Keyboard player and technician Eric Frampton has announced +EF, a completely rewritten firmware for the Moog Memorymoog Plus. It goes on sale on December 1, 2026. The developer promises note-ons up to 2.5 times faster over MIDI, SysEx patch transfers, aftertouch reception and an arpeggiator that syncs to MIDI clock. This article is based on the official firmware page and the full feature list published by the developer (PDF). The news was picked up by Synthtopia.
Who it is for: Memorymoog Plus owners, and their technician
The Memorymoog is Moog’s big analog polysynth from the early 1980s: six voices, three oscillators per voice. The Plus version added MIDI and a sequencer. Polyphony, the number of notes that can sound at once, each with its own signal path, is covered in our guide to polyphonic, paraphonic and monophonic synths.
+EF is a third-party product: the page states it is not authorized or endorsed by Moog Music or inMusic. More importantly, this is not a USB update. The developer’s requirements:
- a Memorymoog Plus in proper working order: it will not work on a non-Plus Memorymoog or with any third-party MIDI interface;
- healthy RAM chips, to be checked before installation with the developer’s diagnostic ROM;
- replacing four EPROMs on the instrument’s boards;
- for pitch bend and pedals over MIDI, the hardware modifications described in the dBm Technical Services update, with parts not included.
In short, this is a job for a technician who knows vintage synths, not a casual weekend install.
What +EF changes
Timing first
The developer says the code was started from scratch: +EF contains none of the original firmware. The headline gain is the delay between receiving a note and triggering it.
According to the published measurements, a MIDI note now fires in 7.2 ms on average, against 17.5 ms with the dBm update. The arpeggiator now follows an LFO or clock input up to 80 steps per second without dropping steps; each step fires a median 6.6 ms after its clock pulse, with at most 0.7 ms of jitter. The “loping”, the uneven swing owners know well, is gone according to the developer.
MIDI
- MIDI notes 36 to 99, without velocity;
- program change 0 to 99, channel 1 to 16 or omni;
- CC1 to modulation amount, CC2 (breath) treated as aftertouch, CC7 to programmable volume, CC40 to oscillator 3 voice modulation, CC64 to stretch envelope release;
- SysEx send and receive, for one patch or the whole memory;
- MIDI clock to the arpeggiator, in quarter, eighth, sixteenth and triplet divisions, with Start, Stop and Continue;
- Tune Request triggers the oscillator autotune.
Aftertouch and the arpeggiator
Aftertouch is the pressure applied to a key once it is down (explained in our aftertouch and MPE explainer). +EF receives MIDI channel aftertouch and routes it, with an adjustable amount stored per patch, to one destination: pitch bend, oscillator 2 or 3 frequency, noise level, modulation amount or rate, filter cutoff or emphasis, VCA level.
The arpeggiator now respects poly voice allocation, stacks voices in MONO mode, and HOLD captures up to 24 notes and keeps them through program changes.
Everything else
- several LFO waveforms active at once;
- programmable volume can be forced to follow the front-panel knob;
- parameter display reads 0 to 255 instead of 0 to 100;
- footswitch jacks auto-detect polarity at boot;
- boots to the last loaded program, autotune report lists each faulty voice.
What +EF removes
To make room in the EPROMs, some features go. This is the point to weigh before buying:
- the internal sequencer and program chains;
- cassette save and verify (loading still works; backups move to SysEx);
- MIDI out, except for SysEx: the Memorymoog keyboard no longer plays other instruments.
Price and availability
+EF goes on sale on the developer’s site from December 1, 2026. Price not announced yet. A preliminary user manual is already online. All our firmware news is in the Firmware Updates section.
How it compares
| Firmware | Strengths | Limits |
|---|---|---|
| Original (MIDI 4.1) | Sequencer, program chains, cassette | Minimal MIDI, uneven arpeggiator timing |
| dBm update | Pitch bend and pedals over MIDI (with mods) | 17.5 ms average latency per Frampton’s measurements |
| +EF | 7.2 ms claimed, SysEx, MIDI clock, aftertouch, dBm features and some LAMM features | No sequencer or MIDI note out, no velocity, Plus only |
For a Memorymoog Plus driven from a sequencer or DAW, +EF addresses the two classic complaints about the instrument: slow MIDI and an unstable arpeggiator. If you play the internal sequencer or use the Memorymoog as a master keyboard, it is not for you. The figures come from the developer and remain to be confirmed on production units.

